HOW TO DO A LEDGER BOARD HOW TO
HOW TO DO A LEDGER BOARD INSTALL
HOW TO DO A LEDGER BOARD FULL

Slip the back flashing under the siding at least 8 cm at the top and the sides.

Slip the siding up and around the door.

Measure carefully to cut around the door.

In order to make a bend at an inside corner, clamp a straight edge onto the piece and score with a knife, and bend carefully.

Use a block and framing square for a 90-degree bend to fit inside the house corner wall-Mark for cutting to length with a square and pencil.

By cutting halfway through you will allow it to bend very easily.

Clamp a straight edge to the surface to ensure a straight line.

Score with a utility knife, but do not cut all the way through.

Tin snips are the fastest and safest tool to cut vinyl flashing. Also, while these instructions are a useful general guide, check your local codes to ensure compliance.

HOW TO DO A LEDGER BOARD FULL

For detailed instructions and photos see the full article below are the highlights.

HOW TO DO A LEDGER BOARD HOW TO

This articleВ provides a step-by-step look at how to DIY flashing. The houseвЂ™s sheathing should be triple protected from moisture - with building paper, or roofing felt stapled to the sheathing then with back flashing and then the Z flashing. Whereas metal (such as aluminium flashing) and extra layers of roofing felt (tar paper) were often used in the past, today, vinyl Z flashing and rolls of vinyl-back flashing provide better protection. The wall flash prevents ice build-up that can expand, contract and move the deck board over time. If you live in an area with a freeze/thaw cycle, this protection is even more critical.

HOW TO DO A LEDGER BOARD INSTALL

Trex RainEscapeВ® Wall Flash is one piece of the overall flashing system you need to keep your timber safe when adding a new deck to your home or replacing an existing deck.Д®specially, if youвЂ™re cutting vinyl siding to install a deck ledger board, you must be careful to ensure moisture cannot touch the timber where your deck and home meet. With a 20-year warranty from Trex вЂ“ the worldвЂ™s #1 deck company - easy-to-install, self-adhesive wall flash is a must-have. Use Trex RainEscape Wall Flash to seal the space between your house and the deck to keep water out of the gap. Given time, this trapped water will cause your timber to become rotten. The first deck board is generally mounted slightly away from your house and leaves a small gap where water and ice can become trapped. Trex RainEscapeВ® Wall Flash minds the gap between your first deck board and your house - this is where water damage can start. With flashing, you can add years to the life of your deck. Stop the rot by being proactive during deck construction.ДЇlashing adds the secret superpower your deck needs to fight water damage and timber rot. Timber that gets wet again and again will weaken and show damage over time. Yet, as you think about what youвЂ™ll see day to day on your beautiful new outdoor space, itвЂ™s essential to think now about what you wonвЂ™t see: the timber that supports your deck. ItвЂ™s fun to dream of what your deck could be. When planning a new deck, itвЂ™s fun to spend time choosing colours and styles for your deck boards and railings.

How to do a ledger board